Hydz D12H7 Piezoelectric Sounder - Low Power, Reliable Supplier from China Factory for Electronics Applications
| Part No：HYR-1240A-05 | ||
| 1 | Resonance Frequency (KHz) | 4.0 |
| 2 | Max Input Voltage (Vp-p) | 30 |
| 3 | Capacitance at 120Hz (nF) | 10±30% |
| 4 | Sound Output at 10cm (dB) | ≥80 at 4.0KHz Square Wave 5Vp-p |
| 5 | Current Consumption (mA) | ≤3 at 4.0KHz Square Wave 5Vp-p |
| 6 | Operating Temperature (℃) | -20～+70 |
| 7 | Storage Temperature (℃) | -30～+80 |
| 8 | Weight (g) | 0.7 |
| 9 | Housing Material | Black PPO |
- Do not apply DC bias to the piezoelectric buzzer; otherwise insulation resistance may become low and affect the performance.
- Do not supply any voltage higher than applicable to the piezo electric buzzer.
- Do not use the piezoelectric buzzer outdoors. It is designed for indoor use. If the piezoelectric buzzer has to be used outdoors, provide it with waterproofing measures; it will not operate normally if subjected to moisture.
- Do not wash the piezoelectric buzzer with solvent or allow gas to enter it while washing; any solvent that enters it may stay inside a long time and damage it.
- A piezoelectric ceramic material of approximately 100µm thick is used in the sound generator of the buzzer. Do not press the sound generator through the sound release hole otherwise the ceramic material may break. Do not stack the piezoelectric buzzers without packing.
- Do not apply any mechanical force to the piezoelectric buzzer; otherwise the case may deform and result in improper operation.
- Do not place any shielding material or the like just in front of the sound release hole of the buzzer; otherwise the sound pressure may vary and result in unstable buzzer operation. Make sure that the buzzer is not affected by a standing wave or the like.
- Be sure to solder the buzzer terminal at 350°C max.(80W max.)(soldering iron trip) within 5 seconds using a solder containing silver.
- Avoid using the piezoelectric buzzer for a long time where any corrosive gas (H2S, etc.) exists; otherwise the parts or sound generator may corroded and result in improper operation.
- Be careful not to drop the piezoelectric buzzer.
Q: What is the resonance frequency of the HYR-1240A-05 buzzer?
The resonance frequency of the HYR-1240A-05 piezoelectric buzzer is 4.0 KHz.
Q: Can this piezoelectric buzzer be used outdoors?
No, it is designed for indoor use. If you must use it outdoors, appropriate waterproofing measures must be implemented to ensure normal operation and protect it from moisture.
Q: What is the housing material and weight of the HYR-1240A-05?
The buzzer housing is made of Black PPO material, and the total weight of the unit is 0.7 grams.
Q: What is the recommended soldering condition for the buzzer terminals?
The buzzer terminals should be soldered at a maximum temperature of 350°C (using an 80W max. soldering iron tip) within 5 seconds, using a solder that contains silver.
Q: What are the operating and storage temperature limits?
The operating temperature range is -20℃ to +70℃, and the storage temperature range is -30℃ to +80℃.
Q: Why should DC bias be avoided on this piezoelectric buzzer?
Applying DC bias to the piezoelectric buzzer may cause its insulation resistance to become low, which can severely affect its overall performance.